so you have missed nothing important before this post.The only interesting thing I have done was on the hole for the “C” hook at the rear end of the lateral plate. I moved it as Kent showed in a post.
.Here it is what I have done yesterday.
The first.
I have worked on the other two holes for the “C” hook at the front end of the lateral side of the hull.
I have fitted them by a “washerous bush”
I glued it by epoxidic resin “Acciaio Rapito” (that means quickly steel).
Because the “bushous” part was a bit longer than the lateral plate thikness
I grinded it
to get the same level
The second.
Kent noticed the armoured semicircle covers for the gear case of the kit were too short (picture by Kent)
Because I am not as skilled as him
I asked a modeller for an help. He made the two pieces by a lathe starting from an aluminium big bar... as you can see in the picture below. 
When he gave me the covers he warned me the two “teeth” were a bit larger to allow me to fit the joints better by an easy work.
As he told me the two pieces did not match each other
So I used a perfect BHC tool (Brain-Hand-Controlled)
To get a acceptable goal
... nay...
two acceptable goals
)
